If your YB3i is not transmitting correctly or your PredictWind GPS tracking page is not updating please check the following:
Ensure the unit is powered, and any connections in the circuit are good.
There is an LED indicator on the bottom of the unit. The LED has the following indicator modes:
Intermittent green flash – running on external power
Intermittent red flash – running on battery
Red/Green alternating – booting up or updating firmware
Off – in shipping mode, stealth mode, or the battery has run out and there is no external powerHardware reset the device by swiping the reset magnet all the way around the outside edge of the unit. The unit will beep after about 10 seconds, and will then be reset.
If the above suggestions do not work, then contact support with the details below:
Name and contact number
The serial number of the Device (see serial number label)
Symptoms of the fault
History of action taken to attempt to rectify the fault
Please remember that the more information you can give us, the better we’ll be able to help you.