GO exec setup Complete! Testing and pre-departure checklist
Congratulations! You have completed the GO exec Setup Guide.
Over the coming weeks, please test your GO exec using the GO exec App and Offshore App often to familiarise yourself with calling, downloading weather GRIBs and running routes.
Important next steps
Review the GO exec Checklist more than a week before leaving port. This will allow enough time to seek help to resolve any issues before you set off.
During your pre-departure testing, please contact us if you get stuck or need help with any issues.
GO exec rubber grommets
Close all the rubber grommets on the ports you are not using to prevent salt water or air from entering. The GO exec IP65 waterproof rating applies only when all the grommets are fully closed.
GO exec Storage when winterising
The GO exec is a critical safety device. When you have finished your voyage or seasonal travel, it is essential to store the GO exec correctly and maintain it so the GO exec is ready to go again when you are.
Half charge the battery. Fully charge if planning to store for six months or more.
Disconnect the device from the charger.
Power down the GO exec into Storage Mode. To do this:
Touchscreen: Tap the Settings cog->Power Off the Device, enable Activate Storage Mode, and tap Power Off.
GO exec App: Tap the Settings cog->Device Settings->Admin Settings->Power off my GO exec device, enable Activate storage mode, then tap Power Off.
Lower the internal antenna.
Cancel your SIM card airtime plan in the Satellite Portal. Do not attempt to remove it from the device.
Place the device in a dry, airtight or waterproof container to prevent moisture build-up.
It will lose a fraction of its charge per month, approximately 1-3%. Lithium-ion batteries can be stored for up to ten years with minimal loss of capacity. If you half-charged the battery and delay your travel plans six months later, reconnect it to the charger and top it up again.
When you're ready to use your GO exec again, connect it to an original Iridium charger and fully charge it before use. To wake up the GO exec from Storage Mode, it must be connected to the power charger. Lift the Internal antenna to power it on.
Do not freeze your battery. This will not improve its storage life. Freezing may destroy the battery by altering its chemistry and create a potential fire hazard.